Rocktron BASS200 User Manual

Page 7

BASS Control

This control provides a 15dB of cut or boost at 100Hz. Rotating this control clockwise will

increase the lower frequencies and, depending on other settings, will generally make your tone

warmer and heavier.

MID-LOW Control

This control provides approximately 15dB of cut or boost at 220Hz.

MID (MIDDLE) Control

This control allows your getting 15dB of cut or boost at 660Hz. Turn it clockwise, the sound

will be fatter and more powerful.

MID-HI Control

This control provides approximately 15dB of cut or boost at 1.6K Hz.

TREBLE Control

This control provides a 15dB of cut or boost at 5k Hz. Rotating this control clockwise will

increase the high frequencies producing a brighter sound.

COMPRESSOR Control

This controls the amount of signal compression. At the full counterclockwise position there is

no compression. At the full clockwise position there is full compression. The sonic effect of

compression is reduced dynamics, increased sustain and a more consistent output level regard-

less of how light or hard the strings are played.

VOLUME Control

This control determiners the overall level (output) of the ampliﬁer.

POWER - On/Off Switch

This turns the ampliﬁer on and off. When the switch is “lit” then the ampliﬁer is “on”.

COMPRESSOR Button

Use this switch to turn ON or OFF the Compressor.

SEND Jack

Use this 1/4″ unbalanced jack to send signal to a professional outboard effects processor. Out-

put level is approximately 0 dB to +4 dB and is post-EQ and post-shape but unaffected by the

setting of the volume control. It can also be used as a Line Out jack if required.

RETURN Jack

Use this 1/4″ unbalanced jack to return signal from a professional outboard effects processor.

This jack can also be used as a Line In Jack if required.

LINE OUT Jack

Use this jack for recording, direct to a PA system, or to a power ampliﬁer.