Rocktron Velocity 100LTD - Manual (Page 5)

5
Rear Panel
POWER Module This module provides a connection for the power cord
and also houses the main fuse of the unit. (For more information about the
changing the fuse, please see page 5)
OUTPUTS jacks (Ch. 2): These ¼" mono jacks provide outputs for
Channel 2 to speaker cabinets. These jacks are configured in parallel.
Important!
Do not use these outputs with loads of 2 Ohms or less.
When using both output jacks to provide multiple
speakers for a given channel, it is important to ensure
that the combination of speaker impedances for the
given Velocity 100LTD output channel does not equate
to a combined impedance of 2 Ohms or less.
INPUT jack (Ch.2): This ¼" jack provides an input to Channel 2 from the
output of a preamp or the device in an effects chain.
OUTPUT jacks (Ch. 1): These 1/4" mono jacks provide outputs for
Channel 1 to speaker cabinets. These jacks are configured in parallel.
Important!
Do not use these outputs with loads of 2 Ohms or less.
When using both output jacks to provide multiple
speakers for a given channel, it is important to ensure
that the combination of speaker impedances for the
given Velocity 100LTD output channel does not equate
to a combined impedance of 2 Ohms or less.
INPUT jack (Ch. 1 MONO): This ¼" jack provides an input to Channel
1 from the output of a preamp or the device in an effects chain. Use this
input if running in MONO. If the Channel 2 input jack is not used, then
the signal from the Input jack (Ch.1) will be sent to both Output jacks
(Ch.1 & Ch.2).
1
2
3
4
5