Rocktron Patchmate Loop 8 - Manual (Page 7)

7
PatchMate LOOP 8 Back Panel...continued....
9 PAS. ACT. OUT
Use this jack to plug into the next unit in your signal chain or the desired LOOP. This jack can
also be used as an output for the guitar signal when splitting the signal.
10 ACTIVE Jack
This jack is used to send your guitar signal to your desired device, such as an amplifier.
11 MIDI OUT/THRU Jack
Use this to jack to plug into the first MIDI controllable device in your signal chain.
12 MIDI IN Jack
Use this jack to plug in your MIDI controller. This jack is a 7 Pin MIDI Jack, however a stan-
dard 5 Pin MIDI Cable can be used. If plugging into a Rocktron MIDI controller such as the All
Access, MIDI Mate or MIDI Xchange, we recommend using the Rocktron RMM900 7-Pin MIDI
Cable (sold separately). Pins 6 and 7 supply phantom power to the Rocktron MIDI controller
when using the RMM900.
13 POWER Jack
Plug the included 9VAC 3.4A adapter into this jack to provide power to the unit. Please follow
all precautions as outlined in this manual and the manuals of the products that are being plugged
into the PatchMate LOOP 8. Failure to follow these precautions may void the warranty.