REFCO STARTEK-C - Manual (Page 4)

English
4
BATTERY INSTALLATION AND
REPLACEMENT
1. Turn the power off.
2. Remove the battery cover from the back of the instrument by
pressing down while simultaneously sliding the cover back.
3. Insert 2 size ‘AA’ alkaline batteries.
4. Slide battery cover back into place.
SENSOR
A STARTEK-C sensor should last many hundreds of hours of continuous
operation. A failed or failing sensor will be indicated by a continuous
“siren” sound. In addition, it is recommended that the sensor be
replaced yearly for optimum performance.
SENSOR REPLACEMENT
In either case, occasional replacement of the sensor is necessary:
1. Turn the power off.
2. Remove the sensor cap by pulling it from the end of the probe.
3. Pull the old sensor from the socket.
4. Install the new sensor. Note that the sensor package has a tab that
needs to be aligned with a slot on the sensor socket.
5. Install the sensor cap by pushing it fully over the sensor.
MAINTENANCE
The STARTEK-C should provide years of service with little maintenance
aside from changing batteries and sensors. The case may be cleaned
with a shop towel moistened with water and a mild detergent. Do not
use solvent of any kind.
English
5
FOR USA CONTACT
REFCO Manufacturing (US) Inc.
109 Independence Dr.
Lockport NY 14094
Phone: (716) 438-2796
Fax: (716) 438-2746
Email: [email protected]
Web site : www.refcoswiss.com
FOR REST OF THE WORLD CONTACT
REFCO Manufacturing Ltd.
Industriestrasse 11
CH-6285 Hitzkirch (Switzerland)
Phone: +41 41 919 72 82
Fax: +41 41 919 72 83
Email : [email protected]
Website : http://www.refco.ch