RAVE Sports Apollo Lounge - Manual (Page 4)

NOTE: It sometimes helps to moisten the valve plug first before inserting it into the valve body.
Proper Use Instructions
To reduce the risk of injury using this product, follow these guidelines:
• Familiarize yourself with the current conditions where you plan to use the product. Use
common sense and caution when using in unfamiliar settings.
• Do not overload the product. Overloading can cause damage to the product and the safety of
the users will be jeopardized.
• Inspect the product before each use. Do not use if there are any signs of deterioration or
damage. Repair or replace before use.
• Take extra care not to have sharp objects on or around this product as it could easily be
punctured.
• The product was designed for leisurely activity. Do not bounce, jump or allow horseplay as it
could result in damage to the product and injury to the user(s).
Cleaning and Storage
• When the inflatable product is not being used, it is recommended that you store it in a
covered, shaded area. This will help protect it against ultraviolet (UV) rays and extend the life
of the product.
• Clean the inflatable completely with a mild soap and fresh water. NEVER USE PETROLEUM
BASED PRODUCTS OR SOLVENTS FOR CLEANING.
• Product should be completely dry while stored.
• Store in a cool, dry location. Do not store product directly on concrete surface. Place
mothballs around stored inflatable to keep mice and insects away.
Repairs
For minor holes or tears:
• Inflate the product and locate the leak by spraying or wiping with mild soapy water or by
dunking it under water. Air bubbles will form and grow at the position of air leakage. Mark
location of leakage.
• Cut a patch larger than the diameter of the hole. Make sure all corners of the patch are rounded.
• Deflate the product and clean the area around the hole. Wipe area with rubbing alcohol to
remove any residue. Let dry.
• Peel backer from patch.
• Lay the product on a flat, hard surface and apply the patch using a dull, hard tool like a wooden
spoon or roller. Working from the center to the outer edge, rub out any air bubbles between the
patch and the product.
• The product may be used right away.
3