RAVE Sports Sky Totter User Manual

Page 13

Step 2 – Cut out a patch approximately 2 inches larger than the leak.
Clean the damaged part of the product and patch and allow to dry
thoroughly.

TIP – It is a good idea to always use a circle or rectangle patch with
rounded corners. Pointed corners tend to pull off.

Step 3 – Next clean the area and the patch with alcohol, grease
remover, or fingernail polish remover and allow to dry thoroughly.

Step 4 - Apply glue in a very thin layer to the patch and then to the
area of the leak. Let the glue stand until tacky, usually 30 seconds – 1
minute.

TIP – Place glue on the dull side of the patch and to the shinny side of
the unit. Then when you apply the patch it will match.

TIP – Use a short brush (just cut the length off) as this digs into the
material better to spread the glue. Also try to use a brush with real
hair instead of synthetic.

Step 5 – Place the patch over the leak

Step 6 – Press out the air pockets which may have formed under the
patch. You can use any round object, such as a spoon, starting in the
center and then working outwards toward the edges. You can keep the
repair “tight” by clamping together with spring pliers.

Step 7 – Allow repair to cure for 24 hours before re-inflating.

Step 8 – Inflate the repaired product.