RAVE Sports O-Zone Water Bouncer - Manual (Page 8)

Troubleshooting
Won’t hold air:
• Check main valve to insure plastic ring is not caught under
the seal or cap.
• Be sure the valve and cap are screwed in straight and tight. A
cross threaded valve can cause leakage.
• Check for holes in product following the procedures in the
“Repairs” section.
Repairs
• Inflate the tube firmly and locate the leak by spraying the tube
with soapy water. Bubbles will appear where there is a leak.
• Determine the hole size and cut a circular patch ½ - 1 inch
wider than the hole.
• Remove air from the tube and dry tube completely where the
patch is to be applied.
• Peel off paper back from patch, apply repair patch to area
and work out any air bubbles from beneath the patch.
• Apply weight to the patched area for one hour before re-
inflating.
7