RAVE Sports Bongo 20 Bouncer Water Park - Manual (Page 2)

Preparation
Lay the Aqua Jump Eclipse or Bongo 20 on a flat surface. Make sure
there are no sharp objects under the product that might puncture the
tube. Ensure the tube is completely opened and the top is facing up.
Locate the valve and inflate the tube to about 2/3rds full (The anchor
harness will be the first item to be attached. Do not attach the surface
and springs to the tube at this time).
While standing inside the partially inflated tube, spread the Anchor
Harness out onto the ground. With the ropes completely spread out,
ensure the ropes are untangled and not crossing each other.
All RAVE anchor harnesses are made using an “offset” design with a
swivel. This allows maximum holding force in high winds.
The AJ150 Anchor Harness will have one long rope running THOUGH
the hole in the nylon glide assembly and one shorter rope tied directly
to the other side of the nylon glide.
The AJ200/Bongo20 Anchor Harness has one long rope and one shorter
rope but both ropes pass freely through the left/right holes of the nylon
glide assembly. The glide must be free to slide along both ropes in
order to maintain equal tension on all ropes, regardless of wind
direction. Ensure both ropes are not tangled or crossed and that the
glide is free to slide along both.
Installation
With the Anchor Harness evenly spread out inside the tube, identify
between the long anchor harness rope, and the short rope.
Identify the size of product you have to the diagrams on the next
page. Connect the end of each rope to the corresponding panel of the
Aqua Jump/Bongo. If you are unsure as to the size of the product you
own, count the number of panels on your inflatable tube, and match
the number of panels to the diagram.
1