Dixon 115 239947 - Manual (Page 8)

8
Remove plastic end caps from the center bag support
arm. Fully insert spacer plug into the end of the
support tube. It may be necessary to tap the spacer
into place with a hammer or mallet. Replace the
plastic end cap back over the spacer. The additional
extension will hold the hood more securely when
latched.
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
Lift and rotate cover to align the cover brackets 1.
with support assembly tubes.
Slide the cover down over the support tubes until
2.
secure.
Remove center
end cap
Insert spacer and
replace cap
ASSEMBLY
7
INSTALLING BAGGER MOUNT
8
MOUNTING COVER ASSEMBLY
9
INSTALLING SPACER PLUGS
Using hardware provided in kit, attach support 1.
mount to unit.
Attach hanger bracket to support mount. Do not
2.
fully tighten nuts at this time.
Secure rear end of support straps to outside of 3.
hanger assembly. Set reinforcement plates to the
outside of the tank brackets and fasten front end
of support strap to tank bracket and reinforcment
plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Rear guard hole may need to be drilled out
to
5 /
16
" if kit hardware is too large.
Hanger Bracket
Support Mount
Support Straps
Reinforcement Plate
Hex Bolt Placement
Round Head
Bolt Placement