Precision Pet Puppy Pen - Manual

Step 1 - UNFOLD
• Stand Pen on floor with handles up. Open the Pen by pulling the left side
then the right side out, causing the Pen to have an appearance of a bow tie.
Pull the sections of the panels which are inverted to form a complete square.
Step 2 - INSERT PAN(S)
• Insert the pan(s) underneath the front door panel. Pan(s) lock
into place between the four legs.
Step 3 - INSTALL FLOOR(S)
• Hold one of the black floor panels so that the four end prongs are towards you and facing down. Standing in front of the front door panel, lower floor panel straight up and
down into the Pen with the two side prongs at the center of the hinged sides. The two side prongs lock at the desired height. The four prong side is lowered and the prongs will
hook & lock over outside edges on the front door panel. (The floors can be placed at any level, giving you five different height options.) * Lower the second floor in the same manner.
Step 4 - LATCH TOP
• The top panel (attached to the panel without a door) is closed by bringing it upwards and placing the side prongs
underneath the top side wire and then latching the side hooks over the top side wire. The other top panel swings up
and is locked by squeezing both top panels together causing the hooks on the front top to latch over rear top wire.
FRONT DOOR
• The front door is opened by squeezing the two latches
together firming and pulling. When closing, squeeze the
latches the push the door firmly shut before releasing the
latches. The door stops will automatically line up the
closing pins.
Setup Instructions
(No Assembly Required) Gives Your Puppy a Place To Call Home!
PUPPY
Pen Pen
* 18" & 24" wide Puppy Pens
have one piece floor
* 48" floors have interlocking
tabs for extra support
FOR 48" PUPPY PEN
INTERLOCKING TABS
LOCKED
For safety, remove dog collars and tags
before allowing dog to enter crate or pen.