beautypg.com

Warning, Instructions for use – Peg-Perego Duette SW Stroller Seat User Manual

Page 7

background image

EN_English

Thank you for choosing a

Peg-Pérego product.

WARNING

• IMPORTANT: READ THESE

INSTRUCTIONS CAREFULLY
AND KEEP THEM FOR FUTURE
REFERENCE. FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD PUT
THE CHILD’S SAFETY AT RISK.

• THIS PRODUCT IS DESIGNED FOR

CHILDREN WHOSE MAXIMUM WEIGHT
IS 45 POUNDS (20 KG) AND WHOSE
MAXIMUM HEIGHT IS 43 INCHES
(110 CM). THIS SHOPPER BASKET IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 11 POUNDS (5 KG). ANY
CUPHOLDER EVENTUALLY PROVIDED
WITH THIS UNIT IS DESIGNED TO
CARRY A MAXIMUM WEIGHT SPECIFIED
ON THE CUPHOLDER ITSELF. ANY
POACH OR POCKET PROVIDED WITH
THIS UNIT IS DESIGNED TO CARRY A
MAXIMUM WEIGHT OF 0.44 POUNDS
(0.2 KG).

• FAILURE TO FOLLOW

MANUFACTURER’S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE UNIT
TO BECOME UNSTABLE.

• AVOID SERIOUS INJURY FROM FALLING

OR SLIDING OUT. ALWAYS USE
COMPLETE 5 POINT SEAT BELT.

• NEVER LEAVE YOUR CHILD

UNATTENDED.

• CHILD MAY SLIP INTO LEG OPENINGS

AND STRANGLE. NEVER USE IN
RECLINED CARRIAGE POSITION UNLESS
FOOTREST ENCLOSURE IS FULLY
INSTALLED/IMPLEMENTED.

• ALWAYS USE ALL THE BRAKES

WHENEVER PARKED.

• TO AVOID SERIOUS INJURY, WHEN

MAKING ADJUSTMENTS ENSURE
THE CHILD’S BODY IS CLEAR OF ALL
MOVING PARTS.

• ALL OPERATING AND ASSEMBLY

PROCEDURES SHOULD BE PERFORMED
BY AN ADULT.

• DO NOT LIFT THE STROLLER BY

GRIPPING THE FRONT BAR. THE FRONT
BAR IS NOT DESIGNED TO WITHSTAND
LOADS.

• ENSURE THAT THE STROLLER IS

OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.

• CHECK TO MAKE SURE THAT THE

CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).

• DO NOT DRIVE THIS PRODUCT

AROUND STAIRS OR STEPS; CARE MUST
BE TAKEN IF UNIT IS USED ON STAIRS
OR ESCALATORS.

• DO NOT USE THE PRODUCT IF IT HAS

BROKEN OR MISSING PARTS.

• DO NOT USE NEAR FIRE OR EXPOSED

FLAME.

• NOTICE: THIS ARTICLE MEETS OR

EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.

instructions for use

CARRIER SEAT

PrimoGiro Seat Unit: the carrier seat for the
PrimoNido bassinet unit. This seat comes with a
cover only, since the hood from the PrimoNido
bassinet unit can be used with the seat once
the baby no longer uses the bassinet unit. The
hood can also be ordered separately.

Duette and Triplette Seat Unit: the carrier
seat for the Duette and Triplette twin carriages.
This seat comes with a cover and a hood with a
zipper that can also be used as a canopy.

SEAT FITTING

1• Fold back the footrest and raise the backrest to

the desired position by pulling the handle on
the rear of the backrest, as shown in the figure.

2• To fit the front bar, remove the plugs onto the

armrests pushing from underneath and detach
the squared bushes from the armrests.

3• Insert the front bar into the armrests and

complete the fitting by replacing the plugs into
the armrests.

TO FIT AND REMOVE THE SEAT

Before fitting and removing the seats, always

apply the brake.

4• To fit the seat to the frame, place it as shown

in the figure and press down with both hands
till it clicks. The seat can be mounted facing the

This manual is related to the following products: