Peg-Perego Book - Manual (Page 16)

- 16 -
INSTRUCTIONS FOR USE
1• OPENING THE STROLLER: before opening the
stroller, attach the back wheels until they
click into place (fig_a). Press on both sides
of the chassis to release the closing hooks
(fig_b).
2• Grasp the main handle and rotate it to open
the stroller (fig_c). Open stroller (fig_d).
The stroller is properly opened when you
hear a click (i.e. the base attaching).
3• For safety, check the seat is properly
attached, as shown in the picture (fig_e).
Lastly, lower the closing hooks (fig_f)
4• ASSEMBLING THE BASKET: Unfasten the
basket tube from its supports by pressing
on the springs below same (Fig_a). Insert
the basket tube through the rear of the
basket, taking care that the springs are facing
downwards (Fig_b). Fasten the shopper bag
to the rear rods by sliding the tube into the
respective supports (Fig_c).
5• Fasten the shopper bag to the front rods as
shown in the figure (fig_d). Slip the basket
loops over the upper and lower hooks (fig_e).
6• LOCKABLE SWIVEL FRONT WHEELS:
The front wheels are already attached to
the stroller.For swivelling wheels, lower the
lever (arrow 1). For fixed wheels, move the
lever in the opposite direction (arrow 2). We
recommend using fixed wheels on rough,
uneven surfaces (fig_a).
BRAKE: to set the brakes on the stroller, lower
the levers on the rear wheels with your foot
(Fig.b). To release the brakes, lift the lever.
Always set the brakes when the stroller is not
moving.
7• CUP HOLDER: The cup holder can be placed
on left or right side of the stroller through the
hook fitted on both sides of the chassis. To fit
the cup holder, click it on (Fig.a).
ADJUSTING THE HANDLES: the handles can
be set into 4 different positions. For the
highest position, push the side buttons and
lift the handle upwards at the same time.
Release the buttons. To lower the handles, do
the opposite (Fig.b).
8• BABY SAFE: Extract the baby safe from under
the footboard bag (Fig.a).
- Unfasten the front bumper (20b).
- Insert the front bumper into the baby safe as
shown in the figure (Fig.b).
- Fasten the front bumper (19).
- Unfasten the bag from the armrests (25d).
- Fasten the side holes of the baby safe to the
fabric’s side connections and then fasten
them to the arm rests (Fig.c).
9• Fasten the baby safe elastic bands sideways
to the seat on both sides, as shown in the
figure.Baby Safe mounted correctly.
10•IMPORTANT: ensure the canopy is properly
buttoned:
onto both sides of the stroller's backrest (Fig.
c) and on the inside of the handlebar (Fig. d).
11• HOOD: to assemble the hood, fasten the
hood's side attachments onto the sockets until
they click (Fig.a). The hood has:
- a fabric loop, for tying toys (Fig.b).
- a window with UV protection, to see the
child (Fig.c).
12• The hood can be adjusted to two positions
(Fig. a).
Undo the zip (Fig. b) and stretch the fabric
flap to see the child and to let more air under
the hood (Fig. c).
13• 5-POINT SAFETY HARNESS: to fasten, insert
the two buckles of the waist strap (with
attached shoulder straps, arrow a) into the
leg divider strap until they click into place
(arrow b). To unfasten them, press the button
which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards
(arrow d).
14• To tighten the waist strap, pull on both
sides in the direction of the arrow. To loosen
it do the opposite.
15• To adjust the height of the safety harnesses,
release the two buckles on the rear of the
backrest.
Pull the shoulder straps towards you (arrow a)
until the buckles are released and insert them
in the backrest loops (arrow b). Remove the
shoulder straps from the sack (arrow c) and
insert them in the most appropriate buckle
(arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles
are securely attached when a click is heard
(fig f).
WARNING: To fasten the belts in the third
eyelet, lift the fabric, as they are hidden in the
lining.
16• FREEDOM OF MOVEMENT: After 6 months,
at the discretion of the parents, the straps
may be fastened differently, to give your
child more freedom of movement, without
jeopardising on safety.
- Detach the two buckles on the rear of the
backrest (as explained in paragraph 15).
- Slide the two buckles out from the front;
- Fasten the buckles, as shown in the figure, on
both sides of the waist strap.