ParkZone PKZ3400 - Manual (Page 18)

16
Reference Information
Binding process
The 2.4GHz DSM2 receiver in the Ember 2 uses a unique binding
operation to link your transmitter with your receiver. Please note that your
radio system has been bound for you already. Should you need to
replace a transmitter or your aircraft, you will need to perform the binding
process as detailed below.
When using a DSM2 transmitter that is a different design than the
Ember 2 transmitter, please refer to your transmitter’s manual for detailed
binding instructions to be used in step 4 below. Confirm that ATV travels
on your DSM2 transmitter are not exceeding 100% prior to binding your
transmitter to the Ember 2.
1. Confirm that the flight battery is fully charged.
2. Confirm that the flight battery is disconnected from the receiver/
ESC unit and the transmitter is turned off.
3. Plug the flight battery into the receiver/ESC unit. After 5 seconds
the LED on the receiver/ESC unit will begin flashing.
4. After verifying that the LED is flashing on the receiver/ESC unit,
turn the transmitter power on while pressing in on the left stick.
(You will here a ‘click’ when you press on the end of the stick.)
Release the stick.
5. If you entered bind mode correctly, you will see a solid LED
approximately 5-10 seconds later on the receiver/ESC unit.
You should now be bound to the transmitter and have full control
and function.
Additional Smartbind™ Information
Prior to each flight, you should ensure that you power on your transmit-
ter and wait about 5 seconds before you plug in the flight battery into
the receiver/ESC unit. Doing this allows time for the transmitter to scan
and secure two open frequencies. If the flight battery is plugged in too
quickly and the link is missed, it may cause the receiver to inadvertently
enter bind mode. If this occurs simply leave the transmitter on and then
disconnect and reconnect receiver power (flight battery).
Should you encounter any problems, repeat the binding process again. If
problems continue, call the Horizon Support Team at 1-877-504-0233.