Danby DAC8007EE - Manual (Page 8)

LED DISPLAY: Displays the following information
independently; Set Temperature, Ambient Room
Temperature and Auto Timer On/Off settings.
POWER: Turns unit On / Off.
MODE: Allows you to scroll through and select
the desired operating mode; Cool
, Dry ,
Fan Only and *Auto .
The selected mode will be denoted by the
adjacent indicator light.
*‘Auto’ is a pre-set
factory program that automatically defines the
mode (Cool or Dry) and fan speed based on the
set temperature.
FAN SPEED: Select from four different fan settings;
Low , Medium , High and Auto
during Cool and Fan Only mode. Please note:
During ‘Dry’ mode the fan speed is automatically
defined .
ENERGY SAVER: Automatically cycles the fan on
and off while the compressor is not in use.
TEMP. /TIMER Control: Used to increase or
decrease the Temperature setting in 1°C / °F
increments.and Auto-Timer On/Off settings in 30
min./1hr. increments.
Auto
Auto
7
Mode
Selector
Temp/Timer
Control
MODE
Auto Auto
Fan
Speed
Power
Button
Energy
Saver
Sleep
Mode
Check
Filter
Key Pad Features
Note: This appliance allows you select the
temperature scale to be displayed in either “Celsius” or
Fahrenheit” according to your preference. To change
the temperature scale displayed on the electronic
display, press both the “Temp/Timer” adjust arrows
simultaneously to alternate between “Celsius” &
“Fahrenheit”.
CHECK FILTER : The adjacent indicator light will
illuminate as a reminder to clean the air conditioner
filter (see page 9) Once the filter has been
cleaned and replaced, depress the Check Filter
button in order to resume operation.
SLEEP MODE : When activated, the current set
temperature is gradually increased over a one (1)
hour period then maintained for seven (7) hours.
Once the program is complete, the air conditioner
will resume to it’s previous set temperature (before
sleep mode was activated). This feature is meant
to be used during the night time hours to prevent
the room from getting too cold (while you sleep)
and results in less compressor running time and
reduced energy consumption. Sleep mode may
be cancelled by depressing the Sleep Mode
button while the program is running.
MODE
Auto
Timer
LED
DISPLAY
AUTO-TIMER: Used to Initiate the Auto On and/or
Auto Off timer.
While the Air Conditioner is off (Auto-On):
1. Press the Auto-Timer button once and the adjacent
Auto-On indicator light ‘ ‘ will illuminate.
2. Use the Temp/Timer control cursors to select a
delayed
On time of up to 24 hours.
3. Select the appropriate mode under which you want
the unit to operate (Auto-Cool-Dry-Fan Only)
4. Select the fan speed setting.
5. The time you selected will appear in the LED
display..
While the Air Conditioner is on (Auto-Off);
1. Press the Auto-Timer button twice and the adjacent
Auto-Off indicator light will illuminate.
2. Use the Temp/Timer control cursors to select a
delayed
Off time of up to 24 hours.
3. The time you selected will appear in the LED display
The Auto On and Auto Off timer can operate during the
same program by defining the Auto-Off parameters
immediately after the Auto On parameters.
The Auto-Timer may be cancelled at any time by turning
the unit On/Off.
68