Features and controls, Features are obtained by using bitwriter, And a 3 pin esp – Directed Audio D1200 User Manual

Page 10: Cable. while a bitwriter, Can only talk to one esp

1100

D1200

D2400

FUSE

40A x 3

FIGURE 2—AMPLIFIER CONNECTIONS - REAR

ESP

FEATURES AND CONTROLS

These amplifiers incorporate an on-board
Directed ESP

Engine. In addition to

allowing menu-driven parameter adjust-
ment*, operate with security products
from Directed Electronics to incorporate
advanced ESP2 features. Your dealer
can use a Bitwriter

with Firmware

version 2.0 or later to access these
parameters.

** NNoottee:: The ESP

features are

obtained by using Bitwriter

and a

3 pin ESP

cable. While a

Bitwriter

can only talk to one

ESP

/ESP2 device at a time,

multiple amplifiers can be set to
respond to Arm/Disarm commands.

Simply repeat the TX ID Learn
procedure for each amplifier. When
completed use a Y-cable to connect
the Alarm signals to both ampli-
fiers.

NNoottee:: Prior to using the anti-theft or
valet features it is recommended
that the alarm be installed and its
functionality verified. Please consult
the install or operations guide for
the appropriate alarm.

For the Bitwriter

to Amp connection,

the cable must have the same color
sequence at both ends of the cable. For
the Alarm to Amplifier, the Transmit and
Receive wires must cross from one end

This manual is related to the following products:

D2400