Directed Electronics S800 User Manual

Page 7

WOOFER INSTALLATION

1. Mark and cut a 7-5/8” (186mm)

hole for mounting the speaker.

2. Drill the holes for the mounting

screws using a 1/8” (3mm) drill
bit.

3. Route the wiring harness through the

mounting hole.

4. Install the spring clips over the

holes if needed. Apply the rear
mounting gasket to the speaker
frame.

5. Attach the wires to the speaker and

be sure to observe proper speaker
polarity.

6. Place the woofer in the hole. Insert

screws through grill clips and
woofer mounting holes. Screw
woofer into place using the six
supplied mounting screws and grill
clips.

7. Press the speaker grill firmly in

place over the grill mounting clips.

FIGURE 1—WOOFER INSTALLATION