Meijiaxin Toys T11 - Manual (Page 7)

Must set the remote controller to the “OFF” position before operating step 1
1. Turn on the helicopter by inserting the battery plug into the battery socket, the helicopter light will keep quickly
blinking for about 3 seconds while the helicopter is checking the middle point of the gyro. Then, the light of the
helicopter will blink slowly, indicating that the helicopter is ready to connect with the remote controller.
2. Turn on the remote controller, the power indicator light of the remote controller will blink slowly, slowly push up
the throttle control stick to the top and then push it down to the bottom.Then, remote controller sends out
connectional signal and the indicator light keep quickly blinking during the signal connection process.Once
signal connection is done,the light of the helicopter and the power indicator light of the remote controller will
stay "ON" without blinking,meaning that the helicopter is ready for flight.
3. Push up the throttle stick and the helicopter takes off.
PREPARATION FOR FLIGHT