Meijiaxin Toys T41C - Manual (Page 3)

Major parts
Charge the helicopter
Preparation for flight
Helicopter
1. Insert the battery plug into the helicopter battery socket located at the right side of the
helicopter, then, the indicator light of the helicopter will keep flashing rapidly, set the helicopter
down to a platform.
2. Slide the power switch to “ON” position. To activate the remote controller, slowly push up the
throttle stick to the top and then push it down to the bottom. The indicator light flashes rapidly
while the remote controller is sending out connectional signal.
3. When the whole auto signal connection process is finished, both indicator lights of helicopter
and transmitter are keep ”ON” without blinking, then push up the throttle stick slowly and the
helicopter takes off.
Camera/
Photograph
switch
Charger
The port of the charger
Camera
Charging plug
� Turn off the helicopter;
� Unplug the battery cable from the helicopter,then,insert the plug of the battery cable into the
port of the charge (matching the plug to the port) to start charging.
�
Once charging is proceeding,red power light of the charge controller is on.When charging is
finished,the red light will turn into green light.
Full charge takes about 2.5 hours.