Martin Archery Martin Compound - Manual (Page 9)

9
Single Cams That Use F Modules
Martin Single Cam systems feature a modular draw length adjustment. A series of draw
length modules are used to adjust draw length in one-inch increments (see below). Draw
lengths can also be adjusted in half-inch increments within each size module.
Parts Of The Single Cam Systems
Speed Bearing
Adjusting The Single Cam Draw Length
Using draw length modules, the draw length can be adjusted in 1" increments. To change
the draw length, replace the module on the cam by removing the screws that hold it to the
cam. NOTE: do not draw your bow without the module installed. It will damage your
harness.
The module sizes range from F-1 to F-7. As the module numbers get higher, the draw gets lon-
ger. The draw length can also be adjusted in 1/2" increments using the pegs on the back of the cam.
This method of draw adjustment applies to ALL Martin Single Cam System (Acu-Trak,
Fuzion, Dyna, M-Pro, and M2).
Module
Screws
Bottom Cam
Idler Wheel
Single Cam String Diagram
The string harness on your Single Cam is installed according to the diagram below. Your
string harness should be installed by your qualified Martin dealer.
Module
Draw
Stop
Return Cable Peg
Speed Bearing
Shooting
String
2nd half
Shooting
String
Split
String