Luxul XMS-1010P - Manual (Page 4)

Quick Install Guide XMS-1010P
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-QIG-XMS-1010P 029151051
4
Indicator Name Description
POWER On Indicates that there is power to the XMS-1010P
Off If LED is off, check power connections and on/off
switch at the back of the unit.
Link/Act On There is a device connected to the port.
Flashing A port is receiving or transmitting data.
Off There is nothing connected to the port.
1000 Mbps On A device capable of 1000Mbps is connected to the port.
Off If a port has no device connected or it is not a 1000
Mbps capable device, the 1000 Mbps LED will be off.
PoE On A PoE enabled device is connected and being supplied
power
Off No PoE enabled device is connected or PoE is not
enabled on this port
SYSTEM On Indicates that the XMS-1010P is booting.
Flashing The XMS-1010P is running normally.
Off The XMS-1010P is in startup and initialization process
or is not on.
At startup, port LEDs will flash for 1 second as a self test.
Reset Button
The Reset button (Located at the lower left corner of the front panel) is used to clear the
current settings of the switch and restore factory default settings.
How to Use the Reset Button
f To Hard Reset the Switch: With the XMS-1010P powered on, press the Reset button.
CAUTION: DO NOT hold the button as this will factory default
the switch
f To Restore the Default Settings: With the XMS-1010P powered on, press and hold the Reset
button until the status of the System LED shows the following: On – flashing – off. You can now
release the Reset button, and the switch automatically restores the factory default settings.
When the System LED start flashing again, the XMS-1010P will be set to factory defaults.
CAUTION: Please note this will remove any configuration done to the switch
prior to Reset.