Lingenfelter L510050197 Lingenfelter C5 C6 Corvette Front Subframe Spacer Kit v1.0 - Manual (Page 3)

Page 2.
1. Open the hood. If you have been driving
your vehicle, allow time for it to cool down before
beginning this installation.
2. Raise the vehicle with a vehicle hoist or
a jack and jackstands. Be careful to follow the
GM lifting procedures on the Corvette due to the
aerodynamic components being easily damaged
and the low ride height of the vehicle.
3. Loosen, but do not remove the four (4)
front subframe nuts. The nut must be loosened
enough for the engine to be raised by 1/2”.
4. Using a prying device for leverage, lift
the engine off of the subframe and insert the
subframe spacers between the engine and
the subframe. A temporary spacer may be
used between the subframe and the engine to
hold the engine up until you are prepared to
install the subframe spacers.
WARNING: DO NOT PLACE YOUR FINGERS
BETWEEN THE SUBFRAME AND THE ENGINE
CRADLE.