Lingenfelter L360080197 Lingenfelter C5 C6 Corvette Clutch Return Spring Kit v1.1 - Manual (Page 9)

Page
21. Locate the 13mm bolt above and slightly
in front of the hood release. There is a brace that
holds the wiring harness to the frame. This must
be removed to relocate the wires away from the
spring on the clutch return spring bracket.
22. Locate the bolt on the frame that is
indicated. There is a nut on top of the frame that
must be loosend to allow the bolt to drop down.
Using two (2) 13mm wrenches or sockets, loosen
the bolt so that you can hook the end of the
spring around it as shown.
23. Pull the bracket and secure it around the
clutch pedal. Using a 1/8” hex key, tighten the
set screw to the pedal and install the retaining nut
onto the set screw.
8.
20. Disconnect the ambient inside temperature
sensor from the lower dash panel.