DCS EH-30SS - Manual (Page 12)

11
Installation Instructions
7) The brackets shown in Fig. 08 are also used to adjust the level of the canopy. Using a Phillips
screwdriver, rotate the screw V2 to adjust the level of the canopy.
8) Connect the Power Supply Cable to the euro hood. Attach the White lead of the power supply to
the White lead of the euro hood with a twist-on type wire connector. Attach the Black lead of
the power supply to the Black lead of the euro hood with a twist-on type wire connector.
Connect the Green ( Green and Yellow ) ground wire under the Green grounding screw.
9) Replace the field wiring compartment cover and the grease filters.
To install grease filter: Put the end of grease filter without the knob into the channel in the
front of hood. Turn knob to the left so the lever does not protrude from filter. Insert knob end of
grease filter into the channel in the back of the hood. Turn knob to the right, locking filter in place.
10)Turn the power supply on.Turn on blower and light. The euro hood controls are located on the
right-hand side under the canopy. If the euro hood does not operate, check that the circuit breaker
is not tripped or the house fuse blown If the unit still does not operate, disconnect the power
supply and check that the wiring connections have been made properly.
DUCTLESS INSTALLATION KITS
The euro hood can be installed ductless in both chimney and no
chimney (under cabinet) installation. To install ductless in a chimney
installation, you must have the ductless chimney kit (model #ECND-
2SS) fig. 09 and the charcoal filter kit (model #ECF) fig. 11. To install
ductless in a no chimney installation (under cabinet) fig. 10 you must
have the charcoal filter kit fig. 11.
The ductless chimney kit consists of an upper chimney (not pictured),
a lower chimney ( A) with two holes for the exhaust air, a ductless
diverter (B) which sits on the canopy of the hood and diverts the air
to the sides of the chimney, and two vent grates (C) to cover the
holes in the lower chimney.
The charcoal filter kit contains two charcoal filters which twist onto
either side of the blower inside the euro hood.
When installing ductless without the optional chimney kit, some
ductwork must be installed to divert the air either out of the top of
the cabinet or to the face of the soffit. The duct work can not
terminate inside the cabinet or into any dead air space.
A
B
C
FIG.09
FIG.11
FIG.10