Legacy Audio Point One - Manual (Page 13)

13
Option 4: Connecting the Point One using a Wavelaunch
Digital Signal Processor
If you are using a Legacy Audio Wavelaunch Digital Signal Processor
in your system, connect the LFE (or Subwoofer Out) output from the
Surround Processor to Input 4 of the Wavelaunch processor.
Output 7 of the Wavelaunch feed into the balanced input of the subwoofer.
Option 5: Connecting the Point One using the High Level Inputs
(from amplifier)
If using the high level inputs it is highly recommended that you connect
them in parallel with your main left and right loudspeakers.
NOTE: DO NOT use the output from a differential Monobloc amplifier as a
high level input to the subwoofer. When using high level inputs from a
stereo amplifier be sure that they are polarized correctly with the power
amplifier, (positive output to positive input, negative output to negative
input.) Failure to do so may result in damage to your subwoofer, power
amplifier and any associated equipment connected to it. Terminating your
wire leads with banana plugs or gold spade lugs is recommended.
Speaker Connections