Labconco HEPA Filter - Manual (Page 2)

Labconco Instruction Sheet 1059800, Rev - Page 2 of 2
6. Place biohazard bag over the open end of the filter,
let the blower pull the bag into the opening sealing
off the contaminated side of the filter. (Fig 4)
7. On the exit side of the filter, loosen the clamp from
the tubing and gently pry it away from the filter.
(Fig 5)
8. Immediately close the bag around the entire filter
and dispose of it according to local and/or federal
regulations. (Fig 6)
9. Turn the blower off.
10. Install the new filter and tighten clamps.
11. Repeat steps 1-10 with the Supply Filter, as necessary.
Figure 4
Figure 5
Figure 6