Konig Electronic Optical - stereo RCA converter - Manual (Page 2)

2
ENGLISH
Introduction:
This digital to analogue audio converter is designed for either home or professional audio conversion.
It converts coaxial and Toslink input signals to analogue stereo audio signals for R/L outputs. This
converter is small in size and easy to install.
Specifications:
• Output: 2x RCA
• Input: Toslink, Coaxial
• Sampling rate: 48 kHz
• Operating temperature: 0°C to +70°C
• Storage temperature: -10°C to +80°C
• Power supply: 5 V DC 1 A
• Power consumption: 0.5 W
Panel description:
Study the panel below and become familiar with the signal input(s), output(s) and power requirements.
BACK UPPER PANEL FRONT
OUTPUT INPUT
Operation:
Before installation, make sure all devices you wish to connect have been turned off.
• Connect the A/V receiver or amplifier to the converter using appropriate Toslink or coaxial cables.
• Connect the audio source device to the converter using appropriate R/L.
• Insert the DC side of the 5 V power supply into the converter and then connect the AC side of the
power supply to the wall outlet.
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
from mains and other equipment if a problem should occur. Do not expose the product to water or
moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION