beautypg.com

General operating instructions, Radio operation, Cleaning and maintenance – Konig Electronic Retro design AM/FM radio ivory User Manual

Page 6: Troubleshooting

background image

6

1. Connect the smaller plug to the AC socket at the rear of the device. Make sure that the plug is

completely inserted.

2. Insert the mains plug to a wall outlet.

GENERAL OPERATING INSTRUCTIONS

On/Off
Switch on the device by turning the volume control Volume clockwise, until you overcome the point of
resistance.
Switch of the device by turning the volume control Volume counter clockwise, until you overcome the
point of resistance.
Volume control
Increase or decrease the volume by rotating the volume control Volume to the left or right.

RADIO OPERATION

Select with the FM, MW or LW buttons the desired frequency band.
Advice for better reception

FM: Fully extend the telescopic antenna and turn it for better reception.

MW and LW: The device has a built-in antenna. Change the position of the device if reception is
poor.

Frequency adjustment

Tune in the desired station by rotating the frequency scale. Rotating clockwise increases and
rotating counter clockwise decreases the frequency.

The current adjusted frequency for selected band can be read on the frequency scale.

Tone control
Adjust the tone by rotating the knob Tone. By rotating to the left the bass is intensified, rotating to the
right intensifies the treble.

CLEANING AND MAINTENANCE

Please observe also the safety advices.

Before cleaning always pull the power plug.

Clean the housing with a soft and moist cloth and a mild detergent.

Never use abrasive detergents or sharp utensils.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the unit for repair. If you are unable to
solve a problem by following these tips, consult your dealer or authorized service center.
WARNING: Never open the device. Always refer service or maintenance to authorized customer
service personnel.

PROBLEM

POSSIBLE CAUSE

SOLUTION

GENERAL

Power cord not connected or no
batteries inserted.

Connect the power cord correctly or
insert batteries.

Volume is set too low.

Adjust the volume.

Batteries are exhausted.

Replace the batteries.

No sound

Batteries inserted incorrectly.

Change to the correct polarity.

RADIO

Weak signal.

Adjust antenna:
FM: telescopic antenna.
AM/LW: adjust unit.

Poor reception

Interferences by other appliances
(TV sets, VCRs, computers, etc.)

Keep distance to other electric
appliances.