Konig Electronic Wireless headphones 863 Mhz User Manual

Page 4

Step 6:

Before using the headphones, the batteries need to be charged. Take the charging cable with the

2.5 mm power jack and plug it into the recharging socket of the right shell of the headphones.
Note: Leave the headphones to charge for 24 hours before first use. Second and subsequent

charges take about 10 hours.
The red charge LED will light up indicating that charging is in progress.

Operation:

Switch on the audio providing appliance and adjust its volume to roughly a quarter of the maximum

setting. The transmitter will switch on automatically. When the audio appliance is switched off the

transmitter will automatically switch off after 4~5 minutes.
Note: If the volume output is too low the transmitter will switch off or switch to standby mode and

the SIGNAL/POWER LED will not light up. It is not possible to charge and listen at the same time.

Charging has priority.

Step 1:

Switch on the headphones and the POWER LED

will light up.

Do not turn the volume

to maximum when

switching on the

headphones.