Setting up, Your instant backstop, Terminology – JUGS Sports Instant Backstop User Manual
Page 2: Instant backstop
5. Put one end of the folding Support Pole into one
of the two grommets at the bottom of the INSTANT
BACKSTOP
®
.
Place the strap from the Slipcover into
the metal buckle attached to the grommet. For indoor
use only, please attach Crutch Tip to bottom of Support
Pole once the Support Pole is through the grommet.
5
3. The INSTANT BACKSTOP
®
should now be lying flat on
the ground in a 9-foot circle.
3
1. Grasping the edge of the net frame, remove screen from
carrying bag and remove the elastic retention strap.
1
9. The Support Pole with Slipcover must be on the inside
of the INSTANT BACKSTOP
®
frame at all points.
9
Always inspect your INSTANT BACKSTOP
®
before each use. Do not use the INSTANT BACKSTOP
®
if it shows signs of excessive wear or damaged components.
4. Put folding Support Pole together at its maximum
length of 25 feet. Slide blue Slipcover over
assembled folding Support Pole.
4
2. Holding the net frame together, toss away from your
body onto a clear, level area.
2
8. With two people, one on each side, raise the INSTANT
BACKSTOP
®
to an upright position. NOTE: The bottom
of the INSTANT BACKSTOP
®
must be spread to its
maximum width to stand properly.
8
SETTING
UP
your
INSTANT
BACKSTOP
®
6. Attach the Support Pole with Slipcover to the sides
and top of the INSTANT BACKSTOP
®
with the 15
Velcro
®
Straps.
10. With two people, one on each side, pull the Red Straps at
the front of the INSTANT BACKSTOP
®
to a 45° angle to the
ground. When both Red Straps are tight and the INSTANT
BACKSTOP
®
is upright, attach the end of the Red Straps
to the floor with Suction Cups and Tethers. If outdoors, use
Threaded T-Handle Pegs to secure Red Straps to ground.
10
6
7. Place the other end of the Support Pole into the other
grommet. Place the strap from the Slipcover into the
metal buckle attached to the grommet. For indoor use
only, please attach Crutch Tip to bottom of Support
Pole once the Support Pole is through the grommet.
7
11. Secure the D-Rings on both sides of INSTANT
BACKSTOP
®
using Suction Cups and Tethers. If
outdoors, use Threaded T-Handle Pegs to secure
D-Rings to ground. Your INSTANT BACKSTOP
®
is
now ready for use.
11
Support Pole
Slipcover
Frame
TERMINOLOGY
Velcro
®
Loops
Slipcover with
Folding Support Pole
Net Frame
Net
Red Strap
D-Ring
Metal Buckle
Grommet
Crutch Tip
Velcro
®
Loops
Red Strap
Metal Buckle
D-Ring
Grommet
Crutch Tip
INSTANT BACKSTOP
®
SUPPORT
POLE
SLIP COVER
ELASTIC
RETENTION STRAP
THREADED
T-HANDLE
PEG
CARRYING BAG
SUCTION CUP
TETHER
CRUTCH TIPS