JUGS Sports Curveball (2 wheel) Pitching Machine - Manual (Page 13)

• Carefully lift machine from carton and place on level surface.
• Make sure you have all the parts (see figure 3). If any parts are missing, do
not operate the machine until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
• Do not discard the packing materials until you have carefully inspected the
machine, identified all the parts, and satisfactorily operated the machine.
NOTE: If any parts are damaged or missing, do not attempt to plug in the
power cord and turn on switch until the damaged or missing parts are obtained
and are installed correctly.
11
WARNING: To prevent accidental starting or electrical shock that could
cause possible serious injury, assemble all parts to your
machine before connecting it to the power supply. The pitch-
ing machine should never be connected to a power supply
when you are assembling parts, making adjustments, cleaning,
servicing, or when not in use.
Unpacking
1. With the tire side down, place the triangular leg clamp in the leg clamp casting
(see figure 3.)
2. Insert the threaded end of the T-clamp through the center hole in the leg clamp
casting and start the threads.
3. Install one leg in each round hole in the center piece of the leg clamp casting.
Tighten the T-clamp sufficiently to hold the legs in place very snugly.
Set Up