JUGS Sports Super/Softball Pitching Machine - Manual (Page 22)

1. Using the vertical T-Clamp, lock the rotating plate in “Pop-up to Catcher”
position (vertically upward).
2. Make sure the horizontal T-Clamp engages the indentation of the base
shaft. This is done by lining up the horizontal T-Clamp with the red dot on
the base casting, and hand-tightening the T-Clamp.
3. Lower JUGS to a horizontal position, with the Feed Chute facing
upward.
4. Slightly loosen the Base T-Clamp that secures the legs.
5. Grasp two legs, and twist them towards your sides.
6. Tighten the Base T-Clamp.
7. Grasp and lift the two legs. Roll the JUGS as you would a wheelbarrow.
8. Do not roll tires on surfaces that might damage the tire. If the tire becomes
deformed, flat, or damaged, do not use it. Replace tire only with ones the
manufacturer recommends.
NOTE: When you want to instantly move the location of the throw for certain
ground ball and flyball drills, loosen the horizontal T-Clamp enough (6
or 7 turns) so that you can pivot the top of JUGS 360 degrees around
the base. However, when throwing to a specific target is desired, as
in pitching, ALWAYS make sure the horizontal T-Clamp is securely
tightened into the indentation on the shaft located directly above the
red dot on the base casting.
Transporting
20
• Pop-up to Catcher:
By adjusting the vertical T-Clamp, position the feed
chute to point upward vertically for pop-ups to catchers.
The ball will go straight up.