JUGS Sports SMALL-BALL Pitching Machine - Manual (Page 15)

14
1. If setting up the machine for baseball use, connect
Baseball Leg Extensions to the Short Softball Legs,
by squeezing QUICK-SNAP
® buttons and sliding the
pieces together. Be sure the QUICK-SNAP ® buttons
spring back up securely inside the lock holes. (If setting
up for softball use, skip this step and move to step 2.)
2. Insert all three legs into Base using the QUICK-SNAP ®
buttons. Be sure the QUICK-SNAP ® buttons spring back
up securely inside the lock holes.
3. Standing behind the machine (2 legs in front, 1 leg in
back), attach the Machine-Mount Bracket to the Base
by threading the the Vertical-Adjustment Knob through
the right side and into the nut on the left side. With the
Base level, tighten the Vertical-Adjustment Knob.
4. Place the Machine on the Machine-Mount Bracket
with control panel facing rear leg. Thread the Machine-
Mount Knobs through the Machine-Mount Bracket
holes and tighten.
5. Attach the Plexi Feed Chute to the Machine using
two 7/8" screws. Tighten the screws with a Phillips
screwdriver.
6. Slide the Feed-Chute Bracket onto the Plexi Feed
Chute and align the bracket with the two holes on top of
the Machine. Insert and tighten both 1/2” Screws with a
Phillips screwdriver.
7. Slide the Plexi Feed-Chute Extension into the
Feed-Chute Bracket.
RECOMMENDED ASSEMBLY STEPS