Directed Electronics 580 - Manual (Page 17)

17 © 2008 Directed Electronics. All rights reserved.
➤
Remote control progamming
The Reponder LE 2-way remote control has menus for programming the remote to
the system control module and for configuring the remote control user features.
Before you start make sure the keypad is unlocked. (See page 11)
To program the remote user features:
Press and hold the 1.
A U X
button on the remote for 12 seconds. (ignore the
car indicator at 3 seconds). The remote emits one long beep, and the
trasmit LED turns on to indicate the Main Menu.
Press and hold the 2. button for 1. 5 seconds: The remote beeps two-
tmes. You are now in the Remote Configuration menu.
The Lock, Unlock, Remote Start and Aux LEDs turn on and/or blink to indicate
the current remote feature configuration. When the LED is On, the feature is
On.
To configure the remote control features:
Press and release the command button. The LED next to the button turns On or
Off. The remote beeps to indicate the feature configuration.
Press the button to access the Auto keypad lock feature. When the
A U X
LED
is off, the keypad does not lock.
Press the button to change the Auto keypad lock feature.
Lock LED On: The keypad lock feature is On. When the •
A U X
LED is on,
the keypad automatically locks 60 seconds after the last button operation
to avoid accidental command operations. When locked, if any command
button is pressed the remote emits an error tone. The companion remote
beeps once when the feature is programmed On.
Lock LED Off: The keypad lock feature is Off and the keypad does not •
lock. The companion remote beeps twice wthen the feature is programmed
Off.