Imaxrc B606-AC-PRO - Manual (Page 9)

Lithium batteries (Lilo/LiPo/LiFe) program
Press key to the screen on the left, then press key to enter into the parameter
setting menu. You can switch at the same level menu by key. Please refer the detailed
flow chart on the left. When you are willing to alter the parameter value in the program,
press key to make it blink, then change the value with Key. The value will be
stored by pressing key once, and then press key for more than 2 seconds to start
the process.
Mode
Esc
Mode/Esc
Enter
Start
Enter/Start
Enter
Start
Enter
Start
Enter
Start
Dec./Inc.
Dec./Inc.
“AUTO charging” this is for individual Lithium battery or some special battery pack without
balance port or cell count. The left side of the first line shows the type of battery you
selected at the user setting. The right side of the first line shows you the mode of charge. The
value on the left side of second line sets a charge current and the value on the right side of
second line sets the cells count of the battery. The definition of the following screen is all the
same. (To know how to connect, please refer picture B)
“Balance charging” this is for 2-6cells of Lithium battery with balance port, the battery pack
being charged should have the individual cell connect, and connect it to the individual port
at the right side of charger with a suitable connection cable that fits with your battery pack.
(See picture B) In this mode, the charging process will be different from ordinary charging
mode. The internal processor of the charger will monitor and control the voltage of each
cell of the battery pack. This can improve the discharging performance of the battery! EV
charger use the optimized calculation to control the tolerance in the range of +—0.01V!
“Fast charging” select this mode to finish charging process earlier. Principle: When the current
down to 1/5 of the current you set during the CV term, it will stop the process and eliminate
the forcible requirement of the balance precision. (Whether it is been connected to the
balance port), the charging capacity may be a bit smaller than normal charging but the
process time will be reduced.
“Storage mode” this is for charging or discharging Lithium battery not to be used for the time
being. In order to reduce the wastage, you can select this mode to remain the power to 40%
to store. The final voltage are different from the type of the battery, Lilo:3.75V liPo:3.85V
LiFe:3.3V.This is an intellective program, if the voltage of battery at its initial stage is over the
voltage level to storage, the program will start to discharge, and if it is lower, the program
will start to charge automatically. In order to ensure each battery pack meets the demand,
the individual plug of the battery pack should be connected to the individual port of charger.

PROGRAM SELECT
Li** BATT
LiPo CHARGE
2.0A 11.1V(3S)
LiPo BALANCE
2.0A 11.1V(3S)
LiPo FAST CHG
2.0A 11.1V(3S)
LiPo STORAGE
1.0A 11.1V(3S)
LiPo DISCHARGE
1.0A 11.1V(3S)
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Inc.
Dec.