Imaxrc X100 - Manual (Page 34)

Cut off Low Input
Cut off Temperature
Cut off Capacity
Cut off Time
LixxCheckTime
NixxDeltaPeak
Waste Time
Range of setting:10-24V. Lowest cut off input voltage,
charger will stop charging/discharging when input voltage
is lower than setting value.
Range of setting: 40-80°C. Cut off Temperature, char-
ger will stop charging/discharging when temp of batteries
is lower than setting value.
Range of setting: 0.1Ah-10Ah. Safety capacity. Charger
will Stop charging/discharging when capacity of batteries
is higher than setting value.
Range of setting: 10-200mins. Safety time, charger will
stop charging/discharging, when charging/discharging
time is less that setting value.
Range of setting: 5-60mins. Time for checking cells
count of LiPo battery pack.
Range of setting: 5-200mV. NiHm/NiCd Delta peak.
Spacing interval between 2 Cycles. Range of setting:
1-60mins.
Cut off
Low
Input
Cut off
tempe-
raturey
Cut off
Capacity
Cut off
Time
Lixx
Check
Time
Nixx
Delta
Peak
Wasle
Time