Dixon ZTR421 - Manual (Page 8)

BODY REMOVAL
A. ZTR-421 Body Removal
1. Disconnect throttle cable from engine.
2. Disconnect key switch wire loom from frame wire loom
at front of body.
3. ^Disconnect seat switch wire loom from frame wire
loom. This connection is located approximately level
with the back of the seat on left hand side of frame
under the body.
4. Remove four control lever bolts and remove upper
control levers.
5. Remove engaging handle by removing bolt and nut
under handle.
6. Disconnect brake pedal from brake pedal arm by
removing the two bolts.
7. Remove two acorn nuts on front floor and the two sheet
metal screws in transaxle body mount. This also
removes the two brake arm clips. Body will lift clear. To
replace body reverse the above procedure. When
reinstalling the two screws in transaxle body mount,
make certain brake arm retainer clips extend downward
and are parallel with body mount.
B. ZTR-422 Body Removal
1. Disconnect throttle cable from engine.
2. Disconnect two wire loom plugs, one going to engine
wires and one going to switch. Plugs are located
between back of transaxle mount and battery.
OMIT STEP (3) AND FOLLOW ZTR-421 BODY REMOVAL
INSTRUCTIONS FROM STEP (4) ON. REMEMBER TO
REINSTALL SWITCH GROUND WIRE ON LEFT REAR
TRANSAXLE BODY MOUNT SCREW.
C. ZTR-423 Body Removal
1. Disconnect throttle cable from engine.
2. Disconnect terminal running from motor terminal on
switch to frame loom.
3. Disconnect seat switch plug from frame loom. This plug
is located approximately even with back of seat on left
hand side of frame under body.
FOLLOW ZTR-421 BODY REMOVAL INSTRUCTIONS
FROM STEP (4) ON. REMEMBER TO REINSTALL
SWITCH GROUND WIRE ON LEFT REAR TRANSAXLE
BODY MOUNT SCREW.