HITEC HPP-21+ - Manual (Page 2)

HPP-21 PLUS Field Manual HPP-21 PLUS Field Manual HPP-21 PLUS Field Manual HPP-21 PLUS Field Manual HPP-21 PLUS Field Manual
Please note that this manual is for active users’ convenience using HPP-21 Plus in the field.
- For independent usage without PC in the field, please connect HPP-21 Plus to a battery and a servo only.
(Do NOT connect it with a PC.) Then, only the top LED will light up.
- For PC interfaced application, please refer to the enclosed booklet manual for HPP-21.
Potentiometer Knob control
Number indicates its level
Push the
Up button once.
Push the
Down button once.
+
Push both Up &
Down button
at the same time.
Push either Up or
Down button.
/
/
/
/
/
/
/
/
/
/
Push both Up &
Down button
at the same time for 3 sec.
+
Main Menu Index Sub Menu
+ + /
/
/
Test
(Manual Mode) Manual Test 1500us
Anytime
3sec
then push
to return
2100us
900us
Enter
Exit
Fail-safe Test 1.
/ + + / EPA Mode
Move to
Potentiometer
Position
Set
Right or Left
Anytime
3sec
then push
to save
Set Center and
Erase Left/Right
Enter
Exit
Set Fail-Safe
Position
3.
+ /
Anytime
3sec
then push
to return
DB Width Test +
Test
(Auto Mode)
Sweep (speed)
Enter
Exit
Step (speed)
2. /
/ + Fail-Safe Mode
On
(Fast LED Blink)
Off
(Slow LED Blink)
Enter
Exit
4.
+ / Speed Mode
Display
Saved Value
(Fast Blinks)
Display
Potentiometer Value
(Slow Blinks)
Push
to save
Enter
Exit
(Top) = Speed(10%)
(Bottom) = Max. speed(100%)
10 5.
/ + Direction Mode
C.C.W
Blink Fast
C.W
Blink slowly
Enter
Exit
6.
+ / DB Width Mode
Display
Saved Value
(Fast Blinks)
Display
Potentiometer Value
(Slow Blinks)
Push
to save
Enter
Exit
(Top) = Most sensitive
(5th LED) = Most insensitive
5 7.
+ / OLP Rate Mode
Display
Saved Value
(Fast Blinks)
Display
Potentiometer Value
(Slow Blinks)
Push
to save
Enter
Exit
(Top LED) = Off
(2nd LED) = 10%
(6th LED) = 50%
6
8.
/ + Resolution Mode
Normal
(Fast Blinks)
High
(Slow Blinks)
Enter
Exit
9.
+ + Reset Mode
Ready to Reset
(Slow Blinks)
3 sec
Enter
Exit
LED displays
its reset process.
10.
NOTE