HITEC Lynx Sport User Manual
Page 2
I. Introduction
II. Features and Specifications
III. System Layout
IV. Setting and Operation
1. Transmitter
a. Loading Batteries
b. Reading the LED Battery Indicators
c. Recharging Nicd Batteries
d. Transmitter Antenna
e. Changing Crystals
2. Installation of Receiver and Servos
a. Using Separate Power Source for the Receiver
b. Battery Eliminator Circuit with Mechanical Speed Control
c. Connection with Electronic Speed Control
3. Transmitter, Receiver and Servo Settings
a. Checking Operation of the Servo
- Steering Servo Settings
- Steering Servo Trim Setting
b. Throttle Servo Settings
- Using Mechanical Speed Control
- Using Electronic Speed Control
- Using Throttle Servo for Gas Powered Vehicles
Table of Contents
Thank you for purchasing the Lynx Sport, 2 Channel, Pistol Grip, and AM Radio Control
System. The Lynx Sport Radio is made of high quality, technically advanced components
designed to achieve top performance from your RC vehicle. Team up with Hitec Racing
and see that quality and performance doesn't have to cost a fortune!
I. Introduction
II.Features and Specifications
- Pistol Grip 2 Channel AM Proportional System
- Servo Reversing Switches (Both Channels)
- 2 L.E.D. Battery Status Indicator
- Nicd Battery Charging Jack
- Power Output: 500Mw
- Current Drain: 180 mA
III. System Layout
THR
NOR
REV
NOR
REV
ST
REVERSE SWITCH
Steering Reverse Switch
Steering Trim
Antenna
TX Crystal Holder
Power Switch
Throttle Trigger
Steering Wheel
LED Battery Indicator
Charging jack
Battery cover
Throttle Trim
Throttle Reverse Switch
1
2
www.hitecrcd.com
AM
PROPORTIONAL
STEE.
THRO.
HIGH
LOW
ON