HITEC Flash 5 SX - Manual (Page 5)

5
III. System Layout
1. Channel Assignment
Channel 1: Aileron
Channel 2: Elevator
Channel 3: Throttle or Flap
Channel 4: Rudder
Channel 5: Gear or Aileron/Elevon or Flap/Flaperon function. (Flash 5 System X model only)
2. Mode 1 and 2 Information
As shipped from the factory, your radio was set up to operate in either Mode I or Mode II configuration. Mode I means that the
four primary controls have been assigned to work from the sticks in the following manner: The right stick controls the ailerons (Ch
1) and throttle (Ch 3) and the left stick will control the elevator (Ch2) and rudder (Ch 4). Mode II, the dominant style within the
United States, will have the right stick operate the ailerons (Ch1) and elevator (Ch2) and the left stick will operate the throttle
(Ch3) and rudder (Ch4). See page 11 of this manual for complete details of how to change the stick mode if desired.
SW#2 TRAINER
SW#1 (3 POSITION)
(FLASH 5 SYSTEM X ONLY)
THROTTLE / ELEVATOR TRIM
THROTTLE / RUDDER(MODE2)
ELEVATOR / RUDDER(MODE1)
RUDDER TRIM
CHARGING JACK
POWER SWITCH
ANTENNA
NECK STRAP EYELET
SW#3 (3POSITION)
(FLASH 5 SYSTEM X ONLY)
SW#4
(FLASH 5 SYSTEM X ONLY)
ELEVATOR / THROTTLE TRIM
AILERON / ELEVATOR(MODE2)
AILERON / THROTTLE(MODE1)
AILERON TRIM
CRYSTAL
LCD DISPLAY INPUT KEY