Hatteland Display HT B22 (Fanless) - Manual (Page 21)

DOC101356-1_ - rev 2 – 2013-09-24 - Created by:6644
Page 21 of 24
Hatteland Display AS, Åmsosen, N-5578 Nedre Vats, Norway
Tel: (+47) 4814 2200 - [email protected] - www.hatteland-display.com
HD CAN Module Programmer’s Guide (Linux)
All intellectual properties belongs to Hatteland Display AS
l)
J2534_ERROR_CODE J2534::PassThruStartPer
iodicMsg
( unsigned long ChannelID,
PASSTHRU_MS
G
* pMsg,
unsigned long
*
pMsgID,
unsigned long
TimeInterv
al
)
This function will immediately queue the specified message for transmission, and repeat
at the specified interval. Periodic messages are limited in length to a single frame
message of 12 bytes or less, including header or CAN ID. If the function is successful, a
value of STATUS_NOERROR is returned. The Pass-Thru device must support a minimum
of ten periodic messages.
Parameters:
[in] ChannelID The channel ID assigned by the PassThruConnect function.
[in] *pMsg Pointer to message structure(s).
[in] *pMsgID Pointer to location for the message ID that is assigned by the
library.
[in] TimeInterval Time interval between the start of successive transmissions of
this message, in milliseconds. The valid range is 5-65535
milliseconds.
Returns:
Status, see function return codes in hdj2534.h .
m) J2534_ERROR_CODE J2534::PassThruStopMsgFilter
(
unsigned
long
ChannelID,
unsigned
long
FilterID
)
This function removes the specified filter. If the function is successful, a value of
STATUS_NOERROR is returned. After this call the FilterID will be invalid.
Parameters:
[in] ChannelID The channel ID assigned by the PassThruConnect function.
[in] FilterID Filter ID that is assigned by the PassThruStartMsgFilter function.
Returns:
Status, see function return codes in hdj2534.h .