Harmonic Resolution Systems HRS Analog Disk - Manual

HARMONIC RESOLUTION SYSTEMS
ANALOG DISK
Introduction
Thank you for purchasing the Harmonic Resolution Systems (HRS) Analog Disk record clamp. When used
properly, it will give you many years of superior musical signal reproduction. The HRS Analog Disk is designed to
significantly reduce the negative impact of air and structure borne vibration on your record playback accuracy.
The HRS Analog Disk is also a perfect match for the HRS Isolation Base. While the Analog Disk significantly
reduces air-borne, record, and turntable generated vibration, the HRS Isolation Bases or Rack System significantly
reduce the amount of structure-borne vibration that reaches the turntable from the surrounding environment.
Warnings:
The Analog Disk is designed for use on tangential arm turntables with a solid (non-threaded) spindle. When
the record is finished playing the cartridge should not come in contact with the Analog Disk. Prior to use, the
Analog Disk you should be checked to make sure there is no interference with your particular turntable
configuration at the end of record play. If there is interference then the Analog Disk should not be used as it
may result in undesired damage to the stylus or cartridge.
Use and Instructions
The Analog Disk is designed for use on tangential arm turntables with a solid (non-threaded) spindle. Check the
fit of the center hole of the Analog Disk on your turntable spindle. It is intentionally design for a snug contact fit
with the spindle. With a slight push and twist the custom polymer surface of the Analog Disk should come in direct
contact with the album and remain in contact once pressure is removed. If you find that the Analog Disk grips
your spindle then place a very small amount of dish soap or oil, using a Q-tip or tissue, at the entrance to the
spindle hole in the Analog Disk. This will allow the Analog Disk to slide freely with slight pressure onto the spindle
and establish proper contact with the record surface. Repeat lubrication as necessary to ensure optimum
performance.
Care and Maintenance
The HRS Analog Disk is a very low maintenance item that will provide many years of trouble free performance by
applying these basic care instructions.
Clean the Analog Disk using a lint-free soft (non-abrasive) cloth. Use a damp cloth with water or mild soap if
required. Do not spray with or immerse in water.