Grandview GPCN-D - Manual (Page 2)

1-1
1-2
1-3
2-1
2-2
2-3
3-1
3-2
3-3
2-6
2-4
2-5
1
3
2
Install on
the flat
ceiling
GPCN-D200 GPCN-D3040 GPCN-D4060
Connect
main bar
and adjuster
(screws of
accessory ④)
Parts
GPCN-D is combined by GPCN and GPD
GPCN Main Bar Overview
1-1 Top Cap
1-2 Fixation
1-3 Sliding Adjusting Hole
2-1 Main Bar
2-2 Subsidiary Bar
2-3 Front Ornament Board
2-4 Back Ornament Board of Main Bar
2-5 Back Ornament Board of Subsidiary Bar
2-6 Moving Button
GPD Adjustment Overview
3-1 Adjuster
3-2 Hanging Button
3-3 Horizontal Adjusting
Hole
4-1 Installation Bracket
4-2 Vertical Adjusting Hole
4-3 Installation Arm
4-4 Adjustable Screw
4-5 Sliding Installation
Button
4-6 Installation Base
Accessories:
① M6x25 Tapping Screw (4sets)
② 6x50 Wood Screw (4pcs)
③ M5x8 Philips Screw (2pcs)
④ M5x16 Philips Screw (6pcs)
⑤ M5x8 Philips Screw (4pcs)
⑥ M4x8 Philips Screw (4pcs)
⑦ M3x8 Philips Screw (4pcs)
Scope for installation (Installation hole of projector):
Maximum scope for installation:360mm diameter
Minimum scope for installation:50mm diameter
Note: Connect the installation arms to the projector conversely for different installation
holes of projector.
Scope
Maximum diameter: 360mm Minimum diameter: 50mm
Scope for installation (H is the distance between ceiling and projector)
The H of GPCN-D200 is 200mm
The H of GPCN-D3040 is 300mm~400mm
The H of GPCN-D4060 is 400mm~600mm
Scope
Three steps of installation
Install the fixation on the ceiling (screws of accessory ① or ⑧ )as
figure 1, and the fixation also can be installed on the ceiling which
angle is less than 15°as figure 2. GPCN-D can be installed to the
concrete-roof with ceiling or without ceiling, such as figure 3.
Connect the GPCN Main Bar Overview to the fixation (screws of
accessory ④ ). Store the power wire, and then fasten the front and
back screws of main bar. Finally, install the ornament board of
main bar as figure 4 and figure 5.
Hang the installation bracket (projecter has been installed) to the
adjuster as figure 6. And then put in the screws (accessory ③).but
do not fasten.Pull the top cup to the main bar, and then invaginate
the spring as figure 7
Install on
the ceiling
which angle
is less than
15°
Three steps of installation
figure 1
figure 2
figure 3
figure 4
figure 5
15°
figure 6
figure 7
3-3
4-1
4-2
4-3
4-5
4-6
4-4
H
H
H