Golden Blount Alpine Linear Burner - Manual (Page 6)

LIGHTING INSTRUCTIONS FOR
“STP” SPARK-TO-PILOT CONTROL VALVE MODELS
To Turn OFF Gas To Appliance
1. Turn off switch or remote.
1. “Stop!” First read the safety information at
the left.
2. Remove two screws from sides of burner
and take off decorative front to access
control compartment.
3. Install two “D” batteries into Battery Pack
located in control compartment.
4. Replace Decorative Front
5. Turn
on switch, wall switch or ON/OFF
remote connected to wire leads tagged
“For Remote or Wall Switch”
Decorative
Front Screw
On/Off Switch
A. The Golden Blount appliance has a pilot which must
be lit by hand. When lighting the pilot, follow these
instructions exactly.
B. Before Lighting, smell all around the area for gas. Be
sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch, do not use any
phone in your building.
• Immediately call your gas supplier from your
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it. Call a qualified
service technician. Force or attempted repair may
result in fire or explosion.
D. Do not use the appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the gas log set and to replace any part of
the control system and any gas control system and
any gas control which has been under water.
E. FIREPLACE DAMPER MUST BE FULLY OPENED.
WARNING: WARNING: WARNING: WARNING: WARNING: IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS EXACTLY, A FIRE
OR EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY
OR LOSS OF LIFE
FOR YOUR SAFETY,
READ BEFORE LIGHTING
Gas Control
Valve
Battery
Pack
Control
Module
Pilot Burner
Location
LIMITED WARRANTY
Alpine Linear Burners are warranted against
defective materials and/or workmanship for five
years from date of purchase.
Safety Pilot Assemblies, Gas Control Valves, Flame
Sensors and other ignition components are covered
for one year.
This warranty does not cover parts subjected to
misuse, abuse, improper handling or improper
installation. The GB warranty specifically excludes
any liability for indirect, incidental or consequential
damage to property.
Defective parts should be returned to your dealer or
to the factory prepaid with a copy of your sales
receipt. Defective parts will be repaired or replaced
at the factory’s option and returned to you prepaid.
GOLDEN BLOUNT
4301 WESTGROVE DRIVE
ADDISON, TX 75001