Glow-worm Hideaway 80BF - Manual (Page 13)

13 221763A
SIDE VENT GRILLE Diagram 5.1
SIDE VENT GRILLE
(If required, will fit to
left or right side casing)
PLASTIC PEG
SIDE CASING
(R.H. SHOWN)
0885
5 Casing Location / Fitting
TOP CASING FITTING Diagram 5.3
STRAP FITTING (No top casing) Diagram 5.4
0909
PEG POSITIONS IN TOP CASING
A = FRONT EDGE FLUSH
B = 10mm (
3 /
8
in) FRONT OVERHANG
AB AB
SIDE CASING
DOOR BOILER SHOWN WITH
ROLLED EDGE FLUSH
SIDE CASING
DOOR BOILER SHOWN WITH
SQUARE EDGE FLUSH
AB AB
No.8 SECURING
SCREW
SIDE CASING
(R.H.)
CAPTIVE
NUT
STRAP fitted when no
top casing
B
A
B
A
SIDE
CASING
(L.H.)
TOP CASING PLASTIC PEG (4)
0914
SIDE CASINGS FITTING Diagram 5.2
MAX.
MIN.
MID.
MAX.
SIDE
CASING
(L.H.)
MAX.
MID.
MIN.
MIN.
BOILER PLINTH
FRONT
CASING
BRACKET
MID.
No. 8 SCREW
(4)
UPPER
CASING
BRACKET
LOCATING
LUG AND SLOTS
0886
5.3 Top Casing
The top casing can be fitted in four alternative positions, that is,
with either a rolled or square front edge, flush with the door or
overhanging it.
Select either a rolled or square front edge and for a flush fitting
top casing, fit four plastic pegs into holes “A” as shown in
diagram 5.3. For overhanging top casing, fit four plastic pegs
into holes “B”. The plastic pegs are a tight fit so they are best
pushed home with a flat faced tool.
Fit the top casing by engaging the pegs in to the holes in the side
casings and then make sure they are fully engaged by pushing
the pegs down.
For boilers fitted under work tops, not using the casing top, the
strap should be fitted as diagram 5.4.