Glow-worm Heartbeat 4 - Manual (Page 6)

6 221905B
Cleaning
Turn the fire off and allow it to cool before attempting any
cleaning.
Normally the fire will only need dusting. The bright metal trims
may be cleaned with a damp cloth and dried with a soft duster.
Obstinate marks can be removed from the guard and trims using
soapy water. Never use abrasive cleaners.
Glass Panel
Remove any stains on the glass panel with a non-abrasive
cleaner such as a ceramic hob cleaner. Do not use abrasive
cleaners.
The fire has been designed to so that you can remove the glass
panel without having to call in a service engineer. This allows
you to clean the inside of the glass.
To remove the glass panel assembly:
Unscrew and remove the two knurled screws which are under
the outer case canopy, see diagram 6.
Pull the top of the glass panel surround forward, see diagram 6.
Lift the surround up to clear the slots in the case apron.
Diagram 7
9489
FIREBOX
BACK RIB
Instructions for Use
SIDE
LEDGE
SIDE
LEDGE
SIDE
VIEW
FUEL BED
Put the surround in a safe place.
Remove the glass panel assembly by turning the screws each
side of the frame
1 /
4
turn anticlockwise. A tool is provided with
your fire for turning the screws. Lift the assembly clear, see
diagram 6.
After cleaning, replace and secure the glass panel assembly to
the firebox by turning the two screws
1 /
4
turn clockwise with the
tool provided. Replace the surround. Make sure that the outside
edges of the surround sides are inside the outer case.
Ceramic Coal
This product uses a fuel effect piece containing Refractory
Ceramic Fibres (RCF), which are man-made vitreous silicate
fibres. Excessive exposure to this material may cause temporary
irritation to eyes, skin and respiratory tract. Consequently, it
makes sense to take care when handling this article to ensure
that the release of dust is kept to a minimum.
Although light coatings of soot are usually burnt off during
normal use, the coal may benefit from occasional cleaning.
Should any soot accumulation become excessive, the fuel
effect piece should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the
open air by gently brushing with the pieces held away from your
face so that you avoid inhaling the dust. We do not recommend
the use of a normal domestic vacuum cleaner which may blow
dust back into the air.
The coal can be lifted out of the fire box when the glass panel
surround and glass have been removed as described above.
When replacing the coal, make sure that it rests on the ledges
at the sides of the firebox and that its back face is touching the
horizontal rib at the back of the firebox, see diagram 7.
Replace the glass panel assembly and surround after cleaning.
Replacement Parts
If replacement parts are required apply to your local supplier.
Please quote the name of the appliance and Part No. required.
Diagram 6
9486
GLASS
PANEL
SURROUND
9488
GLASS PANEL ASSEMBLY
KNURLED
SCREW (2)