E-Z-GO TERRAIN 250 - Manual (Page 51)

5 - 5
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle while
lifting.
To raise the entire vehicle, install chocks in front and behind each front wheel. Center the jack
under the rear frame crossmember. Raise the vehicle enough to place a jack stand under the
outer ends of the rear axle.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack at the center of the front axle. Raise the vehicle enough to place jack stands
under the frame crossmember as indicated.
Lower the jack and test the stability of the vehicle on all four jack stands.
If only the front or rear of the vehicle is to be raised, place the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
WHEELS AND TIRES
A tire explosion can cause severe injury or death. Never exceed the inflation pressure rating on
the tire sidewall.
To reduce the possibility of tire explosion, pressurize tire with small amounts of air applied inter-
mittently to seat beads. Due to the low volume of the small tires, overinflation can occur in sec-
onds. Never exceed the tire manufacturer’s recommendation when seating a bead. Protect face
and eyes from escaping air when removing a valve core.
To reduce the possibility of severe injury caused by a broken socket when removing wheels, use
only sockets designed for impact wrench use.
DO NOT use low inflation tires on any E-Z-GO vehicle. DO NOT use any tire which has a recom-
mended inflation pressure less than the inflation pressure recommended in the owner’s guide.
Use caution when inflating tires. Overinflation could cause the tire to separate from the wheel or
cause the tire to explode, either of which could cause severe injury.
Tire Repair
Tool List Qty. Tool List Qty.
Lug wrench, 3/4" ......................................................... 1 Impact socket, 3/4"..................................................1
View from Underside of Vehicle
Lifting The Vehicle
Center of
Front Axle
Flat Portion
of Frame
Outside End
of Rear Axle