ENMET Motorized Sample Pump - Manual (Page 6)

ENMET Corporation Sample Pump Kit
4
4.0 Troubleshooting 4.0 Troubleshooting
4.1 Pump won’t turn on:
§ Put pump on charge (12 – 16 hours).
§ Check output of charger.
4.2 Pump running, audio and visual alarms activated:
§ Check tubes for obstructions, fluid or particulate.
§ Check input filter.
§ Charge pump (12 – 16 hours).
§ Check output of charger.
If unable to achieve proper operation of pump contact ENMET or your local distributor.
5.0 Maintenance 5.0 Maintenance
5.1 Storage:
Store the pump and associated equipment in a clean, dry location.
5.2 Charging:
Do not charge the battery continuously. If the pump is not used for a period of time, exercise the battery by running
the pump until the battery reaches "Low Batt" alarm then recharging the battery for 14 – 16 hours.
5.3 Replacement Part Numbers:
ENMET Part Number Description
73081-101 Input Filter
67019-102 Battery Pack
67019-001 Battery Pack; for S / N 1000 and above
67051-025 Charger, 110VAC
67051-027 Charger, 220VAC
03700-018 Wand assembly
73073-001 Flexible tubing, sold by the foot
73073-017 Fitting, quick release, male
04805-006 Pump, for S / N 1879 and below
04805-008 Pump, for S / N 1880 and above
6.0 Warranty 6.0 Warranty
ENMET warrants new pump assemblies to be free from defects in workmanship and material under normal use for a
period of nine months from date of shipment from ENMET. The warranty covers both parts and labor. Equipment
believed to be defective should be returned to ENMET within the warranty period (transportation prepaid) for
inspection. If the evaluation by ENMET confirms that the product is defective, it will be repaired or replaced at no
charge, within the stated limitations, and returned prepaid to any location in the United States. ENMET shall not be
liable for any loss or damage caused by the improper use of the product. The purchaser indemnifies and saves
harmless the company with respect to any loss or damages that may arise through the use by the purchaser or others
of this equipment.
Material shipped to ENMET for warranty evaluation must be packed so it is not damaged in shipping. Material
damaged in shipment is not covered by warranty.
This warranty is expressly given in lieu of all other warranties, either expressed or implied, including that of
merchantability, and all other obligations or liabilities of ENMET which may arise in connection with this
equipment. ENMET neither assumes nor authorizes any representative or other person to assume for it any
obligation or liability other than that which is set forth herein.