EMP Tek E41-B - Manual (Page 6)

Model 41-SE/B
Speaker Type Bookshelf -way Bass Reflex
Frequency Response: 0Hz – 0kHz ±dB
Sensitivity: 88dB (.8V @ 1M)
Recommended Power: 0-100 Watts
Woofer: (1) 4” (10mm) Beryllium Cone
Tweeter: (1) 1” (5mm) Silk Dome
Impedance: 8 Ohm
Crossover Frequencies: ,000 Hz
Crossover: 1dB/Octave
Dimensions: Width: -/4” (171mm)
Height: 11-1/” (9mm)
Depth: 10-1/4” (0mm)
Grille Color: Black Fabric
Finish: Black Oak Wood Grain with Gloss Black Tops and Bottoms
Weight: 1 lbs. (5.44 Kg)
Specifications
Troubleshooting
No sound from
speakers
No sound from
one speaker
Very little bass
and/or imaging
Speaker wire not connected
Speaker selector on amplifier is
not on
Balance control on receiver
or pre-amp is not centered
Speaker wire not securely
connected
Speakers are wired out of phase
Make sure wire is connected
at both the speaker and the
amplifier observing proper
polarity
Activate proper selector on
amplifier
Place balance control in the
center
Check all connections at
amplifier and speakers
Check entire system for proper
polarity and make adjustments
as necessary
Probable Cause: Solution: Situation: