Elenco Variable Voltage Power Supply Kit - Manual (Page 5)

MOUNTING THE TRANSFORMER & BINDING POSTS
r Peel the backing off of the label
and place it onto the case top,
while carefully lining up the
holes as shown in Figure A.
The label should fit snug within
the indentation in the case.
r Install the binding posts with
the colors in the order as
shown in Figure B. Insert the
post into the hole and fasten it
with the nut and lockwasher.
Tighten down the nut with
pliers.
r Install the transformer as shown
in Figure B. Use a 6-32 x 3/8”
screw, #6 lockwasher, 6-32 nut,
and two #6 fiber washers on
each side to fasten in place as
shown.
r Cut the red wires on the
transformer off close to the
transformer.
These wires will be used on
the PC board.
Figure B
#6 Lockwasher
6-32 Nut
6-32 x 3/8”
Screws
#6 Lockwasher
#6 Fiber washer
#6 Fiber washer
Transformer
#6 Fiber washer
#6 Fiber washer
Case top
Binding post
lockwashers
Binding
post nuts
Black binding post
Red binding post
Cut these two
wires (red)
Figure A
-4-