Electrocompaniet ECI 3 - Manual (Page 2)

Unpacking the ECI 3
Immediately upon receipt of the ECI 3, inspect the carton for possible damage during shipment.
The carton and packaging have been designed to provide the safest possible protection for
transport of your integrated amplifier.
Unpack the unit carefully. Save all packaging materials for future shipment.
The contents of the carton
1 pcs Electrocompaniet: ECI 3 integrated amplifier.
1 pcs AC main cord.
1 pcs spare Main Fuse, (located in the fuse drawer).
1 pcs inspection card.
1 pcs remote control.
2 pcs batteries.
2 pcs ECP5XLR (XLR to RCA adapter)
Set up procedure
Before connecting the ECI 3 to the mains, check that the mains voltage indicated on the rear
panel corresponds to the line voltage in the territory were you intend to use the unit.
How to avoid damages
Do not under any circumstances connect or disconnect equipment when power is turned on.
The design of the RCA plug generates a huge transient when inserted.
Connecting or disconnecting equipment with the power on can result in severe damage to both
speakers and amplifier.
How to avoid noise problems
The ECI 3 contains delicate circuits that are sensitive to magnetic strayfields.
The unit should not be placed near mains transformers, TV sets etc. Care should also be taken
regarding placement of the interconnect cables. Do not run interconnect cables in parallel with
main cords or speaker cables. Keep interconnect cables as short as possible.
How to avoid possible antenna problems
In some set-ups hum may occur when you connect the radio, VCR or TV to your system.
The problem is caused by DC voltage coming from your antenna.
Please contact your cable network operator.
1
GB USA